Your Star Map

Setup and care instructions. It takes about five minutes.

Print or save as PDF

What is in the box

Star platein a safety wrapper
Wood baseMaple, Mahogany or MDF
12V power supplywith on/off switch
Microfiber towel
White gloves
Cleaning spray
1

Unpack

Open the shipping box and lift out three things: the wood base, the plate (still in its safety wrapper) and the power supply. Set them on a clean, flat table.

2

Unwrap the plate

Put on the white gloves. Peel the safety wrapper off the plate, then hold the plate by its edges so fingerprints stay off the surface.

3

Slide the plate in

Slide straightdown into the slot

Find the slot in the top of the wood base. Hold the plate upright, line its bottom edge up with the slot, and slide it straight down until it sits snug.

4

Power it up

SWITCH ON

Plug the power supply into the base, then plug the power supply into a wall outlet. Flip the switch on the power supply to ON and your star map lights up.

Caring for your plate

Switch the power supply off and unplug it first. Put on the gloves, lightly spray the plate and wipe it gently with the microfiber towel.

Caring for your base

Keep water and spray off the wood base. Clean it with a dry towel only.

Good to know

  • Handle the plate by its edges and wear the gloves to keep it clear.
  • Always switch off and unplug before cleaning.
  • If the acrylic sheet breaks, we will replace it free of charge, once. Contact us with your order number and a picture.
  • Questions? We are happy to help at our contact page.